Bender EDS460 - Menu 3: Settings

Operation
49
EDS460-490_D00085_01_M_XXEN/02.2016
6.6.3 Menu 3: Settings
The following menu items are available for configuring the EDS…:
Menu item Function Page
Exit Exit settings -
1.General Configure the fault memory, trigger, rated
frequency and type of system.
50
2.Channel Configure the following in respect of each
measuring channel: Response value, measu-
ring transformer type, response delay, delay
on release, measuring transformer monito-
ring, filters for systems with inverters, and
alarm when the residual current has been
exceeded.
51
3.Relay Set the relay mode of operation and type of
fault that you wish to cause a switching ope-
ration for common alarm relay.
55
4.History Erasing the history memory 56
5.Language
Select the language for menu and alarm texts 56
6.Interface Configure the BMS bus address of the EDS… 56
7.Alarm-
addresses
Setting of bus addresses for devices whose
alarm messages are to be displayed on this
EDS…-D.
57
8.Clock Configure the time, date, date format and
summer time changeover.
57
9.Password Changing and activating the password. 58
10.Factory
setting
Resets every setting to its factory setting. 59
11.Service For Bender service staff only. 59