Bender EDS460 - Settings Menu 3: Relay

Operation
55
EDS460-490_D00085_01_M_XXEN/02.2016
6.6.3.3 Settings menu 3: Relay
You make the settings for the common alarm relays K1 and K2 in this menu (eit-
her individually or common to all alarm relays). Selecting a relay
1. Use the "" button to go to the relay channel setting. Press "↵".
2. Use the UP/DOWN buttons to select a relay (1, 2) or for both relays
(1…2). Press "↵" to confirm your selection.
1.Relay mode
Set the relay mode of operation:
N/O-T N/O operation. Relay switches in the event of an alarm or a test.
N/C-T N/C operation. Relay switches in the event of an alarm or a test.
N/O N/O operation. Relay only switches in the event of an alarm.
N/C N/C operation. Relay only switches in the event of an alarm.
If the relay settings only differ slightly, we recommend the
following procedure for the EDS490:
- first set all the relays (1…12) to the same value;
- then modify the settings of individual relays.
Relay: 1
Exit
1.Relay mode:N/O-T
2.Alarm: on
Setting
a single relay:
Relay: 1...2
Exit
1.Relay mode:N/O-T
2.Alarm: on
Setting
both relays: