Operation
64
EDS460-490_D00085_01_M_XXEN/02.2016
The "Settings" menu displays the following settings:
6.6.6 Menu 6: Info
This menu displays standard information on the EDS…-D (for details refer to
„Displaying standard information“ on page 41).
Menu item Function Page
Exit Exit Settings -
1.General Configure the fault memory, trigger, rated
frequency and type of system.
50
2.Channel Configure the following in respect of each
measuring channel: Response value, measu-
ring transformer type, response delay, delay
on release, measuring transformer monito-
ring, filters for systems with inverters, and
alarm when the residual current has been
exceeded.
51
3.Relay Set the relay mode of operation and type of
fault that you wish to cause a switching ope-
ration for the common alarm relay.
55
4.Factory
setting
Resets every setting to its factory setting.
59
5.Service For Bender service staff only. 59
To Next Page
Loading...