Bender ISOMETER iso685-D-P User Manual

Device communicationDevice communication
iso685-D-P_D00170_00_M_XXDE/06.2016
67
Legend for user interface
5
Main menu of the web server (first level)
•START (1)
•DEVICE (2)
• ALARMS (3)
• PARAMETER ADDRESSES (4)
Refer to “Web server device menu (first level)” on page 65.
6Menu
ISOMETER® and EDS settings.
Adjust device settings here.
7Info
• Indication of device information regarding software, measurement
technique, Ethernet and BS bus address.
• Indication of Modbus information for the individual parameters.
To be able to see this information, the selection box at PARAMETER
ADDRESSES (4) for the question "Display additional Modbus informa-
tion for each parameter?" must be activated.
8
System OK/
alarms
Indication of the system status "System OK" (green button) and "Alarms"
(red button).
If there are pending alarms, click on the red button or go to menu point
"ALARMS" (3) to obtain further information.
9
Alarm/
meas.val-
ues
Overview of alarm values and measured values.
10 i symbol
Click on the "i" symbol on the right side to obtain further information
regarding measured values.

Bender ISOMETER iso685-D-P Specifications

General

Brand	Bender
Model	ISOMETER iso685-D-P
Category	Measuring Instruments
Language	English