TEBEVERT III INVERTER SYSTEM (120 VDC)
07.11.2011 30 028-0009-006
4.2 SETTINGS OF THE STATIC BY-PASS SWITCH
(SBS)
The Static By-Pass Switch (SBS) is factory set to default values. (See
Chapter 3.7 / Technical data or the specification sheet). It is not usually
necessary to change these settings.
However, if the units are exchanged or there are different operating
conditions, the settings must be checked or readjusted.
Qualified personnel may only carry out alteration of the
settings on the unit. The altered settings must be clearly
marked on the unit.
On the rear side of the SBS unit there are 2 sets of DIP switches S1 and
S2. (See Figure 12)
To Next Page
Loading...
