64
Cause Remedy
The projector is not
correctly connected to
the input signal device.
Check the connection.
The input signal has not
been correctly selected.
Select the correct input signal with the
key.
Blurred image
Cause Remedy
The projection lens is
not correctly focused.
Adjust the focus of the lens. See "Fine-tuning
the image clarity" on page 36.
The projector and the
screen are not aligned
properly.
Adjust the projection angle and direction as well
as the height of the projector if necessary.
The auto focus and auto
2D keystone functions
did not work.
Try to move and lift up the projector a little bit.
Remote control does not work.
Cause Remedy
The batteries are out of
power.
Replace both of the batteries with new ones.
There is an obstacle
between the remote
control and the
projector.
Remove the obstacle.
You are too far away
from the projector.
Stand within 8 meters (26 feet) of the projector.
To Next Page
Loading...
