BenQ LU960ST - Notice on Laser; Laser Class; Laser Parameters

English
7
9. Do not step on the projector or place any objects upon it. Besides probable physical damage
to the projector, doing so may result in accidents and possible injury.
10. Do not place liquids near or on the projector. Liquids spilled into the projector may cause it to
fail. If the projector does become wet, disconnect it from the power supply's wall socket and
call BenQ to have the projector serviced.
Do not remove
This equipment has a three-pin grounding-type power plug. Do not
remove the grounding pin. As a safety feature, this plug will only t a
grounding-type power outlet. If you are unable to t the plug into the
outlet, contact an electrician.
Notice on laser
Caution – use of controls or adjustments or performance of procedures other than those
specied herein may result in hazardous radiation exposure.
Do not point laser or allow laser light to be directed or reected toward other people or
reective objects.
Direct or scattered light can be hazardous to eyes and skin.
There is a potential hazard of eye exposure to laser radiation if the included instructions are not
followed.
Do not allow to look into the projector beam at any distance from the projector. An adult should
supervise the children to prevent exposure risks.
Check that there is no one looking at the lens, when using the remote control for starting the
projector.
Do not look at the projected light using optical devices(binoculars, telescopes, magnifying glasses,
reectors, etc).
Laser class
This Laser Product is designated as Class 1 during all procedures of operation and complies with
IEC/EN 60825-1:2014.
Laser parameters
Wavelength 449nm - 461nm (Blue)
Mode of operation Pulsed, due to frame rate
Pulse width 1.15ms
Pulse repetition rate 120Hz
Maximum laser energy 0.76mJ
Total internal power >100w
Apparent source size >10mm, at lens stop
Divergence >100 mili Radian