USER HANDBOOK 2.0 | DC20XX, ET20XX, ECC21XX SLIM
Berghof Automation GmbH | Harretstrasse 1 | 72800 Eningen | www.berghof.com
Dialog-Controller-DC20XX_EN.docx
The device is intended for installation within enclosed control cabinets of industrial machines and systems in
indoor areas.
When installing the device, check that the seal profiles are undamaged.
For operation, refer to the applicable statement of ambient conditions (see “Technical data”).
1.7. Transport and storage
The device is susceptible to impacts, heavy vibration, moisture and extreme temperatures.
Transport and storage
Protect the device against major mechanical stresses during transport.
Always pack the device in its original packaging for transport.
For storage, refer to the applicable statement of ambient conditions (see “Technical data“).
Protect the device against condensation and damp.
Operation
If the device has been stored or transported in cold weather or under conditions or large fluctuations
in temperature, do not start to operate it until it has acclimatised to room temperature for the place it
is used.
If condensation is present, wait at least 12 hours before starting to operate the device.
1.8. Unpacking
Or receipt of the device, a check must be made that it is complete and undamaged.
1st Check the packaging for external damage.
2nd If the packaging is seriously damaged or if damage to the contents is evident: Do not proceed further
with opening the packaging, instead immediately inform the transport company and your supplier.
3rd Remove the packaging and keep it safe for subsequent transport.
4th Check the contents for evidence of damage in transport.
5th Check the contents for completeness against the order documentation and keep all the delivery
documentation for future reference. The delivery documentation contains important information
about the device and is part of the product.
6th If you discover damage in transport or the contents do not match the order: Inform the supplier
immediately.
To Next Page
Loading...
