Instruction Manual
3737
5.2 FIRST ACTIVATION
After the physical installation of the instrument has been completed, the electronic converter can be
powered on by plugging in the battery pack to the connector or by connect it to the DC mains.
Depending on the instrument configuration, the M10 can be shipped with the battery pack
disconnected or already inside the meter and connected.
If disconnected: the unit is automatically operative once connected to mains power or when the battery
pack is installed (see 4.6.4 / 4.7).
If already connected: the unit is suspended and needs to be activated. To activate a suspended unit, it is
necessary to swipe the magnet.
A sequence of 7 views will be displayed:
Firmware checksum and
version
Bootloader checksum and
version
Test LCD “ALL ON” Test LCD “ALL OFF”
Converter ID
Measure view
EEPROM secured
Replace battery:
-NO: do nothing
-YES: swipe the magnet
To Next Page
Loading...