BERMAD M10 - Storage and Moving; General Installation Requirements

M10
Instruction Manual
16
4 INSTALLATION
4.1 STORAGE AND MOVING
4.1.1 Storage
To ensure the correct maintenance of the device while waiting for its installation, it is necessary to comply
with the storage provisions below:
1) Store the device in a dry place and protected from dust
2) Keep away from direct and continued sunlight
3) Keep the device in the original packaging until it is used
4) Temperature of the storage place: -40 ÷ +70 °C (-40 ÷ +158 °F)
4.2 GENERAL INSTALLATION REQUIREMENTS
IMPORTANT NOTE! THE SENSOR MUST ALWAYS BE COMPLETELY FULL OF LIQUID!
4.2.1 Vibrations

DO NOT expose the flowmeter to vibrations and/or movements that could aect its performance and
duration.

Install a suitable anti-vibration protection if vibrations occur.
AVOID EXCESSIVE
VIBRATIONS
AVOID EXCESSIVE
VIBRATIONS
AVOID EXCESSIVE
VIBRATIONS
Fig. 3 The pipe must always be completely full of liquid
Fig. 4 Avoid vibrations
Fig. 5 Installation with anti-vibration protections