BERMAD M10 - Product Disposal

To Previous Page

Instruction Manual

8 PRODUCT DISPOSAL

If you decide to put the converter out of service because it is deﬁnitely no longer in use, disconnect it from

the electrical power source and from the cables connected to the sensor before proceeding to its removal

and its disposal.

Disposal of the device is the responsibility of the user who must comply with the speciﬁc laws regarding

environmental protection of the country of installation.

MANUFACTURER’S STATEMENT

The manufacturer declares that the design, development and construction of the ﬂowmeter have been

carried out in compliance with the Directive on the reduction of the use of dangerous substances with

particular attention to waste electrical and electronic equipment (WEEE) and supporting, from an envi-

ronmental point of view and for the protection of the health of the worker, the intervention of the subjects

who participate in the installation, use and disposal of their products (manufacturer, distributors, con- sumers,

involved operators in WEEE treatment).

The crossed-out wheeled bin symbol (Fig. 48) contained on the equipment indicates

that the product must be SEPARATELY collected from other type of waste at the end of

operational life.

Therefore, the user must give the equipment at the end of its life to the appropriate waste

collection centers for waste electrical and electronic equipment or return it to the retailer

when purchasing a new equivalent type of equipment.

Appropriate sorted waste collection for further sending of the fallen to disuse equipment for recycling,

treatment and environmentally compatible disposal contributes to avoid possible negative eects on

the environment and favors the reuse and/or recycling of the materials the equipment is made of. Un-

authorized disposal of the product by the user results in the application of the administrative sanctions

provided for by the applicable law.

Fig. 48

www.bermad.com

The information contained herein may be changed by BERMAD without notice. BERMAD shall not be held liable for any errors.