Instruction Manual
55
1 INTRODUCTION
IMPORTANT WARNING! It is very important that all personnel working with the equipment have read and
understood the instructions and indications provided in this manual, and that they follow them prior to
using the equipment itself. The manufacturer assumes no responsibility for the consequences resulting
from improper use by the worker.
The worker will be responsible for the suitability of the device for particular purposes.
The warranty will be considered void in case of improper installation and use of devices (systems).
The manufacturer shall bear no responsibility for any damage caused by improper use, improper
installation or tampering of own products. Installation, connection, commissioning and maintenance
must be carried out by personnel who are qualified and authorized for this purpose. The personnel in
charge of the installation must make sure that the measurement system is properly connected as per
the wiring diagram indicated in this document.
The manufacturer shall bear no responsibility for any damages or injuries resulting from any misunderstanding
of this manual. In order to avoid possible accidents to persons or things caused by incorrect interpretation
of the instructions, the user must not proceed with operations and/ or interventions on the meter if
there are uncertainties or doubts regarding the operation(s) to be performed. We recommend contacting
Assistance Service for clarifications in this regard for more precise instructions.
The manufacturer will be held responsible only if the meter will be used in its original configuration.
For applications that require high working pressures or use of substances that may be dangerous for
people, the environment, equipment or anything else: In case of pipe breakage, BERMAD recommends to
take the necessary precautions such as adequate positioning, protection or installation of a guard or safety
valve, before installing the meter.
The device contains live electrical components, therefore installation, checks and maintenance must be
carried out by experienced and qualified personnel who are aware of all necessary precautions to be taken.
Before opening any internal part, please disconnect the power supply.
1.1 MANUFACTURER’S STATEMENT
Stresses and loads possibly caused by earthquakes, strong winds, fire damage, vibrations and natural
disasters were not taken into account in the phase of product designing.
Do not install the product in such a way that it acts as a focus for stresses on the pipes. External loads
were not taken into account in the device configuration.
While the device is working, the pressure, supply voltage and/or temperature values indicated on the
label or in this Operating Manual must not be exceeded.
1.2 PACKAGING VERIFICATION
At the moment of purchase and/or upon receipt of the product, the buyer is strongly advised to check the
quality of the packaging which must be intact, without visible dents and completely and correctly closed.
When opening the packaging, also check that the product complies with the information on the packing
list in terms of completeness of components/accessories.
NOTE: All BERMAD software packages are available on the USB flash drive key that accompanies the product.
The software can also be downloaded from the website www.euromag.com by accessing the Download
Area. A free registration will be required after which you can download the configuration software for
your product.
To Next Page
Loading...