BERMAD M10 - Page 54

M10
Instruction Manual
54
DETECTED
ANOMALY
POSSIBLE CAUSES
CONVERTER
BEHAVIOUR
DISPLAYED ICONS
& CORRESPONDING
ERROR CODE
POSSIBLE SOLUTIONS
Bluetooth Error Not working Bluetooth
communication
The error condition
is displayed
601
Power reset the
instrument, by
disconnecting all
power sources.
If the problem persist
contact service center
Main Power
interruption
Main power interruption
detected
Supply voltage out of
operating range
The error condition
is displayed
701
Check the power
supply network
Firmware
checksum
diers from the
attended value
The internal program
memory has changed
The error condition
is displayed and the
program execution
stopped
801
Try to update the
firmware
Parameters’
checksum
diers from the
expected value
The parameters data are
corrupted
The error condition
is displayed and the
program execution
stopped
802
Restore factory
settings
A watchdog
reset was
performed
A disturbance caused an
unhandled behaviour in the
regular software execution
The instrument was
reset to restore the
functionality; the
alarm is cleared after
it has been displayed
901
If the problem
persists contact
service centre