Bernette Airlock b64 - Changing the Presser Foot

Setting up the machine
26
2020-09 EN 5040064.00A.04
Changing the presser foot
Prerequisite:
• The needles are in the top position.
• The presser foot is raised.
> Press the Release Button on the rear side of the Presser Foot Shaft.
– The presser foot is released.
> Lift the Presser Foot Spring slightly and remove the presser foot.
> Lift the Presser Foot Spring slightly and place the new presser foot beneath the shaft groove so that the
shaft groove lies exactly above the Presser Foot Pin.
> Lower the Presser Foot Shaft carefully until the shaft groove engages with the Presser Foot Pin.
> Raise the presser foot.