Threading
55
2020-09 EN 5040064.00A.04
Threading the Looper Threads UL/blue, LL/red
Due to the Air Threader all of the Looper Threads can be threaded in one step.
Prerequisite:
• (see page53)
• Threader Cover is opened.
• Upper Looper Cover hooked in/hooked out is checked.
> Set the Air Threader Connector to the left position.
> Slowly turn the Handwheel counterclockwise until the Air Threader Pipes couple.
> Feed the thread through the Thread Guide.
> Pull a thread reserve of approx. 56 cm so that the thread can be completely drawn through the Air
Threader Pipe.
To Next Page
Loading...
