Threading
56
2020-09 EN 5040064.00A.04
> Place the end of the thread approx. 1.2 cm into the corresponding Air Threader Nozzle.
> Press and hold the Air Threader Button.
– The automatic thread feed into the Air Threader starts.
– The Looper Thread is shot through the Air Threader Pipe and exits at the Looper Tip.
> As soon as the Looper Thread exits out of the Looper Eye, release the Air Threader Button.
> Place the Looper Thread under the presser foot to the back left.
> Repeat the process with the other Looper Thread if required.
> Set the Air Threader Connector to the right position.
> Close the Threader Cover.
To Next Page
Loading...
