Bernina 770 QE - Attaching the Hoop; Overview Embroidery Functions

Embroidering preparation
150
Attaching the hoop
> Raise the needle.
> Raise the embroidery foot.
> Hold the hoop with the right side of the fabric up with the attaching mechanism to the left.
> Position the hoop under the embroidery foot.
> Press both attaching mechanisms (1) of the hoop towards each other.
> Position the embroidery hoop (2) above the bracket of the embroidery arm.
> Press the hoop down until it clicks in position.
> Release the attaching mechanism (1).
1
1
2
> Press the attaching mechanisms of the hoop towards each other to remove the hoop.
> Remove the hoop.
Overview Embroidery functions
1
2
3
4
5
1 Centering the embroidery hoop to the needle 4 Grid on/off
2 Moving the hoop to the back 5 Motif center
3 Moving the module for the sewing mode 6 Virtual Positioning (is visible while scrolling)