BestCode NExT 86 - Page 192

BestCode Next Series 8 Technical Manual October 2022 Page 178 of 290
Prompt Code
Prompt Name
Prompt Description
10-800D
Ink Empty
"SmartFill ink label required."
Solution 1:
Same as 10-800B, except only occurs at Jet Start.
Prompt Code
Prompt Name
Prompt Description
10-800E
Not Used
-
Solution 1:
Load new Firmware.
Prompt Code
Prompt Name
Prompt Description
11-0001
Makeup
SmartFill Makeup Label Read
Solution 1:
Press OK.
Prompt Code
Prompt Name
Prompt Description
11-0002
Makeup Empty
Makeup fluid level empty.
Solution 1:
Add Makeup to the system: Instructions.
Solution 2:
Replace Makeup level switch.
Prompt Code
Prompt Name
Prompt Description
11-0003
Makeup Low
Makeup fluid level is low.
Solution 1:
Add Makeup to the system: Instructions.
Solution 2:
ReplaceMakeup level switch.
Prompt Code
Prompt Name
Prompt Description
11-0004
Add Makeup
"Action Required: Add SmartFill Makeup"
Written to the event log when a MakeupAdd script runs to reduce the ink viscosity.
Prompt Code
Prompt Name
Prompt Description
11-0005
Add Makeup
Action Required: Add SmartFill Makeup
Written to the event log when a MakeupAdd script runs a double to reduce the ink viscosity.
Prompt Code
Prompt Name
Prompt Description
11-0006
Makeup Fault
Makeup Add Interrupted
Solution 1:
Jet was stopped while the device was performing a Makeup Add. No action required.
Prompt Code
Prompt Name
Prompt Description
11-0007
Makeup Full
Makeup tank full, do not add makeup.
Solution 1:
Self-descriptive.
Prompt Code
Prompt Name
Prompt Description
11-0008
-
"Makeup level has fallen to Good."
Written to logs to indicate that the level detect has fallen from Full to Good.
Prompt Code
Prompt Name
Prompt Description
11-0009
Makeup
"Makeup Life is at maximum."
Occurs after trying to Scan a Makeup SmartFill label after very little Makeup usage since last scan.
Helps prevent accidental SmartLabel destruction.