BestCode Next Series 8 Technical Manual October 2022 Page 279 of 290
Positive Air Pump Installation
PERSONAL INJURY & EQUIPMENT DAMAGE: When connected to Supply Power, this Printer produces
Lethal Voltages. Only BestCode trained individuals should service or maintain the Printer. Follow all
local safety codes and regulations. Unless necessary, always disconnect the Printer from Supply Power
when performing maintenance. Unless necessary, never operate the Printer while the Electronics
Compartment door is open. Failure to observe these warnings may result in severe injury or death.
Positive Air Pump Kits are recommended for use in environments with High Humidity, high condensation, or high dust.
The Air Kit will prevent water and dust from entering the printhead and causing issues with High Voltage Trips, gutter
faults, print quality, and Jet Starts/Stop.
1. Locate the mounting PEM for the Air
Pump bracket.
2. Route the Input side of the Air Pump
through the Cable Gland used by the
Main Ink Pump.
To Next Page
Loading...
