BestCode NExT 86 - Page 76

BestCode Next Series 8 Technical Manual October 2022 Page 62 of 290
MOBA Command Mode
The Peripherals page varies
based on the selected Network
Command mode (See Network -2
Command Mode).
This is the screen that will appear
when MOBA command mode is
selected.
The Photocells, Encdoer, Relay,
and Program beacons are all let
alone. However, MOBA uses a
custom Encoding method, so
shaft encoders should no be used
in this method regardless.
Programming Guide for Remote
Communications can be found
here.
Setup: MOBA
Encoder / Divider
Enables or Disables the internal MOBA
Encoder. Set’s the encoder pulse divider.
Delay
Adjust Print position
Lines
Configure for 2, 3, or 4 Rows of data in the
Code
Columns
Sets the number of Characters in the
longest printed row.
Rotation
Rotations the message for printing
Osc. Frequency
Reports or sets the oscillator frequency.
Unicode
Enable or disable usage of Unicode
characters
Echo Characters
Enable or disable the echo of sent
characters back to the MOBA device for
error checking.