Big Joe E30 - Page 25

BL-E30-0515 - 03-01-2018 4-7
Table 4-2 Programmable Parameters
Parameter Factory Setting Description
70A 90A
DRIVE MENU
Accel Max Speed 1.5 sec. 1.5 sec.
Sets the rate (in seconds) at which the speed command
increases when throttle is applied with the speed limit pot is
in its maximum speed position, and the vehicle is traveling
forward. Larger values represent slower response.
Note: Allowable range is restricted by the Accel Min Speed set-
ting.
Accel Min Speed 5.0 sec. 5.0 sec.
Sets the rate (in seconds) at which the speed command
increases when throttle is applied while the speed limit pot is
in its minimum speed position, and the vehicle is traveling
forward. Larger values represent slower response
Note: Allowable range is restricted by the Accel Max Speed
setting.
Decel High Speed 0.6 sec. 0.6 sec.
Sets the rate (in seconds) that is used to slow down the vehicle
when it is traveling forward at high speed and throttle is
reduced. Larger values represent slower response.
Note: Allowable range is restricted by the Decel Low Speed
setting.
Decel Low Speed 1.5 sec. 1.5 sec.
Sets the rate (in seconds) that is used to slow down the vehicle
when it s traveling forward at low speed and throttle is
reduced. Larger values represent slower response.
Note: Allowable range is restricted by the Decel High Speed
setting.
Rev Accel Max Speed 1.5 sec. 1.5sec.
Sets the rate (in seconds) at which the speed command
increases when throttle is applied while the speed limit pot is
in its maximum speed position, and the vehicle is traveling in
reverse. Larger values represent slower response.
Note: Allowable range is restricted by Rev Accel Min Speed
setting.
Rev Accel Min Speed 1.5 sec. 5.0 sec.
Sets the rate (in seconds) at which the speed command
increases when throttle is applied while the speed limit pot is
in its minimum speed position, and the vehicle is traveling in
reverse. Larger values represent slower response.
Note: Allowable range is restricted by Rev Accel Max Speed
setting.
Rev Decel High Speed 0.5 sec. 0.5 sec.
Sets the rate (in seconds) that is used to slow down the vehicle
when it is traveling in reverse at high speed and throttle is
reduced. Larger values represent slower response.
Note: Allowable range is restricted by Rev Decel Low Speed
setting.