BIGTREETECH Manta M8P V2.0 User Manual
24
CM4 eMMC Version
Note: eMMC version will not run the system in the Micro SD card.
1. Install rpiboot
For Windows:
http://github.com/raspberrypi/usbboot/raw/master/win32/rpiboot_setup.exe
For Mac and Linux:
https://github.com/raspberrypi/usbboot#building
2. Toggle switches 4 (USBOTG) and 3 (RPIBOOT) to ON to enter BOOT mode.
3. Connect the Type-C to the computer's USB port (to avoid problems caused by
insufficient computer USB power supply, it is recommended to use an external 24V
power supply for the motherboard), run sudo ./rpiboot(Mac/Linux) or rpiboot.exe on
Windows, and then the CM4 eMMC will be recognized as a large-capacity storage
device by the computer (if rpiboot reports an error at this time, you can try
unplugging and re-plugging the USB).
4. Use the Raspberry Pi Imager software to write the OS image. The steps are exactly
the same as the LITE version.
5. After the writing is completed, power off and toggle switches 4 (USBOTG) and 3
(RPIBOOT) back to OFF. After powering on again, it will enter the normal working
mode.
To Next Page
Loading...
Need help?
General
