BIGTREETECH Manta M8P V2.0 User Manual
36
V2.0 Upgrade Notes
Upgraded MCU to ARM Cortex-M7 STM32H723ZET6 550MHz.
Added interfaces: servo, I2C, 5V detection, TFT expansion ports.
Changed EXP1+EXP2 to FPC connectors.
Increased USB output current.
Added large-capacity energy storage capacitors to the 5V circuit,
especially at the core board 5V input port, to prevent the 5V supply from
breaking due to excessive current during CM4 startup.
Upgraded 12V power supply for increased capacity and resistance.
Precautions
Power off before connecting/disconnecting anything except USB, HDMI
and Ethernet. Includes enabling eMMC flashing.
Pay attention to the heat dissipation issues of CM4 and CB1. If the running
application consumes excessive system resources, it can lead to
significant heating.
If you need further resources for this product, you can find them at
[GitHub](https://github.com/bigtreetech/). If you cannot find what you need, you
may contact our after-sales support(service005@biqu3d.com).
If you encounter any other problems during use or have suggestions or feedback,
please contact us. Thank you for choosing BIGTREETECH products.
To Next Page
Loading...
Need help?
General
