BIGTREETECH MANTA M8P V2.0 User Manual

BIGTREETECH Manta M8P V2.0 User Manual
9
Interface Introduction
USB Power Supply
After powering on the M8P, the LED on the bottom left corner will light up to
indicate normal power supply. The VUSB jumper in the center is for selecting
power - it should only be shorted when powering the board via USB or supplying
power out via USB.
Stepper Motor Drivers
Standard STEP/DIR (STANDALONE) Mode
For drivers like A4988, DRV8825, LV8729, ST820, etc, use a jumper to short
MS0-MS2 based on the microstepping table.
Note: A4988 and DRV8825 require RST and SLP jumpered for proper operation.
Driver Chip
MODE
2
MODE
1
MODE
0
Microsteps
Excitation Mode
DRV8825
Max 32
microsteps,8.2V
-45V 2.5A at
L
L
L
Full Step
2 Phase
L
L
H
1/2
1-2 Phase
L
H
L
1/4
W1-2 Phase
L
H
H
1/8

BIGTREETECH MANTA M8P V2.0 Specifications

General

Brand	BIGTREETECH
Model	MANTA M8P V2.0
Category	Computer Hardware
Language	English