Bil-Jax ESP 19 - Joystick Switches Work but Do Not Light up

37
b. Press "DOWN" and "ENABLE" on the Joystick. Make
sure LED's "DOWN ON" and "HRMTR ON" turn ON. If
not, the main controller may be faulty.
4. For faulty LEFT/RIGHT command:
a. Hold "ENABLE" & "LEFT" switch on the joystick, check
LED’s "PUMP ON" & "LEFT ON" turn ON. If not, the
"LEFT" switch on the joystick or the main controller may
be faulty.
b. Hold "ENABLE" & "RIGHT" switch on the joystick, check
LED’s "PUMP ON" & "RIGHT ON" turn ON. If not, the
"RIGHT" switch on the joystick or the main controller
may be faulty.
•
Joystick Switches Work But Do Not Light Up
-"ENABLE", "UP", "DOWN", steering LED’s do not light up, but the
functionality is fine.
1. "ENABLE", "UP", "DOWN" switches work but the bulbs inside
the switches won't turn ON possibly because of internal bulbs
being blown or the wiring to the bulb may be loose.
2. Steering angle LED display won't turn ON due to possible
following reasons:
a. Blown LED's (very unlikely that all LED's are blown), if
none turn ON, the joystick may not be providing proper
signal.
b. Faulty wiring between the LED board and the joystick
board or a loose connection.
c. The wiring between the steering angle sensor to the
main controller (Steering IN) may be faulty.