8
ALWAYS cordon off area around the base to keep
personnel and other equipment away from it while in
use.
ALWAYS stay clear of wires, cables, and other
overhead obstructions.
ALWAYS disconnect power at the batteries when
not in use to guard against unauthorized use.
NEVER allow electrode contact with any part of the
platform if welding is being performed from the
platform.
NEVER override or by-pass manufacturer's safety
devices.
NEVER release the travel brake or tow the lift
vehicle while a person or materials are on board.
NEVER stand or sit on guard rails. Work only within
the platform guard rail area and do not lean out over
guard rails to perform work.
NEVER attempt to increase working height with
boxes, ladders, or other means.
NEVER operate this equipment when exposed to
high winds, thunderstorms, ice, or any other weather
conditions that would compromise the safety of the
operator.
NEVER climb up or down masts.
NEVER allow ropes, electric cords, hoses, etc. to
become entangled in the equipment when the
platform is being raised or lowered.
NEVER exceed manufacturer's platform load limits
and make sure all materials are evenly distributed
over the entire platform.
NEVER exceed platform load ratings by transferring
loads to platform at elevated heights.
NEVER use guard rails to carry materials and never
allow overhang of materials when raising or lowering
platform.
To Next Page
Loading...
