Binatone iDECT C10i Single - Using Your Phone; Make a Call; Answer and End a Call

12
 
 
 
Enter the phone number (maximum 20 digits) and then press <TALK> to
connect to the line and dial the number. When entering the number, if you
make a mistake, press <DEL/INT> to delete digits.
 
Press <TALK> to connect to the line and then dial the number.
( if you enter a wrong digit you cannot correct it with the <DEL/INT> key.)
 
Press <REDIAL> key in idle mode.
Press <UP/DOWN> to select the desired entry in the redial list and then
press <TALK>to dial out the selected redial number.
 
Press <CALLS/UP> in idle mode.
Press <UP/DOWN> to select the desired entry in the call log and then press
<TALK>to dial out the selected call log number.
 You need to subscribe to Caller Line Identication service to be able
to see the caller’s number or name in the call log.
 
Press <PHONEBOOK> key in idle mode.
Press <UP/DOWN> to select the desired entry in the phonebook and then
press<TALK>to dial out the selected phonebook number.
 
1. When the phone rings, press <TALK>.
2. To end a conversation, press <OFF>.
: When the handset is ringing, please do not hold it too close to
your ear as the volume of the ringing tone may damage your hearing.
 If AUTO ANSWER is set to ON, then lifting the handset
off the base or a charger will answer the call automatically, without pressing
any buttons.
Also, if AUTO HANG-UP is set to ON, then replacing the handset on the
base or a charger will end the call automatically, without pressing any
buttons.