Binatone iDECT C10i Single - Set the Recall Time; Set the First Ring; Set the Dial Mode

31
 
You may need the R button to send a Recall signal (also called Flash or
Timed Break Recall) for network services or if you are connected to a .
You should normally leave the Recall Time at its default setting of Short
(100ms), as this is the standard recall required in the UK telephone network,
but it can be changed to Medium (250ms) or Long (600ms) if your telephone
is connected to a  that requires a different recall time.
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select  and then press <MENU/OK>.
3. Press <UP/DOWN> to select  and then press <MENU/OK>.
4. Press <UP/DOWN> to select  or  and then
press <MENU/OK> to conrm the setting.

When this function is set to Off, the rst ring from an incoming call will not
sound. This is useful on exchanges where calling line identity is sent after
the rst ring.
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select  and then press <MENU/OK>.
3. Press <UP/DOWN> to select  and then press <MENU/OK>.
4. Press <UP/DOWN> to select  or  and then press <MENU/OK>
to conrm the setting.

You should normally leave the dialling mode at its default setting of TONE
(also called DTMF) unless the phone is connected to an old exchange that
only recognises PULSE dialling.
If PULSE dialling is set, during a call you can press < * > to switch to
TONE dialling for the rest of that call.
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select  and then press <MENU/OK>.
3. Press <UP/DOWN> to select  and then press <MENU/OK>.
4. Press <UP/DOWN> to select  or  and then press
<MENU/OK> to conrm the setting.