29
When global is activated, all system handsets and the telephone base
will be silent when there is an incoming call. Press and hold the <
> button
on the telephone base for 5 seconds to turn this feature on. The handsets
will show on their display, and a small light will turn
on just below the < > button on the base. Press the < > button on the
telephone base to turn this feature off.
You can program an individual handset to be silent during predetermined
time frames. This setting is independent to each handset and only silences
the ringer of the handset programmed.
To program the time for an individual handset
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select and then press <MENU/OK>.
3. Press <UP/DOWN> to select from:
The handset enters the DND mode once during the set
time.
The handset enters the DND mode daily during the set time.
Turn DND off.
4. Press <MENU/OK> to select the option.
5. If or is selected, enter the desired start time, in the
format set, using the digit keys and <UP/DOWN> to change between
AM or PM if required. and then press <MENU/OK>.
6. Enter the desired stop time, as above, and then press <MENU/OK> to
conrm the setting.
There is no indication that a DND time has been set, until the
handset enters the DND period, when is shown on its
display.
When global DND is turned on, an individual handset will continue to
be in DND mode even after the set time on the handset ends.
The call barring feature can be set on any handset to prevent it from dialling
any phone number beginning with certain digits that have been set. Three
different barring numbers, each of up to 4 digits, can be set. If a restricted
number is dialled, the call will not be connected, an error tone is emitted
and the handset returns to the stand-by state. The system is required
to set or modify the call barring state, and should be changed from 0000 to
prevent the call bar setting being easily overcome.
To Next Page
Loading...
