service will answer any calls before the answering machine of your iDECT C10i
and prevent it from recording any messages.
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select and then press <MENU/OK>.
3. Press <UP/DOWN> to select
4. Press <MENU/OK> to show and then press <MENU/OK>
again.
5. Press <UP/DOWN> to select the desired setting and then press
<MENU/OK> to conrm.
If you select , the system answers after the third ring
if there are new messages, or after the fth ring if there is no new message.
This allows you to phone in to your system when you are away from home,
to see if there are new messages, and if the call is not answered after three
or four rings, you can hang up before incurring call charges.
Remote operation
iDECT C10i system
Using a tone-dialling phone, dial your home number
You can also use the codes on the other side of this card
While your outgoing message is playing, press
Key in your remote security code
The default code is 0000. For details of how to set a new code,
see the User Guide 8.7.3.4 on page 39.
1
2
3
4
Note:The < > can be entered at any time after the OGA starts playing,
and the 4-digit PIN should follow without any delays. If the 4-digit
Remote Access PIN is entered incorrectly two times consecutively,
the line will be released automatically.
Note: If your answering machine is switched off, the phone will enter into
the remote access mode after 10 rings.
You can then enter the 4-digit remote access PIN
(Default Remote Access PIN is 0000) to activate the remote access feature.
#
To Next Page
Loading...
