Binatone iDECT C10i Single - Remote Code

39
 
Your answering system requires a 4-digit Remote Code to permit access
to the system remotely by any touch-tone telephone. The default Remote
Code is 0000.
 
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select and then press <MENU/OK>.
3. Press <UP/DOWN> to select and then press <MENU/OK>.
4. Press <UP/DOWN> to select .
5. Press <MENU/OK> to show and then press <MENU/OK>
again to display the current remote code ().
 
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select and then press <MENU/OK>.
3. Press <UP/DOWN> to select and then press <MENU/OK>.
4. Press <UP/DOWN> to select and then press <MENU/OK>.
Press <UP/DOWN> to select and then press <MENU/OK>.
5. Use the dial key pad to enter your new 4-digit Remote Code and then
press <MENU/OK>.
6. Enter your new 4-digit code again and then press <MENU/OK> to
conrm your new code.
 
1. When you are away from home, dial your phone number from any
touch-tone telephone.
2. When your answering system answers your call and starts playing your
outgoing announcement, press the key. The OGA will stop playing.
3. Enter your 4-digit Remote Code using the numeric keypad on the
touchtone telephone. If the code is accepted, you will hear a
conrmation tone and the system will start to play any new messages.
If you have no new messages, you must press < 2 > to start playing any
old messages. After the end of the last message, a double beep is
played.