8
Installation and set-up
7 Charge the batteries for 15 hours
Before you use the handset for the first
time, it’s important to charge the
batteries fully.
The handset ‘beeps’ when it’s correctly
placed on the charging cradle.
Leave the handset on the charging
cradle for 15 hours.
8 Connect the base unit to the telephone line
Switch off power at the mains socket
Insert the telephone line plug into the
socket as shown
Switch mains power back on
The ‘battery
charge level’
symbol blinks
Use the plug to
raise the shutter
before pushing it
into the socket
NOTE: the charger pod does not have a
connection to the telephone line.
Make sure the mains socket is
switched on if you want to use
the phone — it will not work
without electrical power
iDect_V2i_IFU_master.book Page 8 Thursday, March 27, 2008 2:54 PM
To Next Page
Loading...
