Binatone iDECT V2i System - Remote Operation; To Activate Remote Control

36
Remote operation
The telephone will allow you to check your messages
remotely from another phone. To use this function you
must be using a tone dialling telephone and you will
need to enter your remote PIN (default: 123).
The remote control function must be activated before it
can be used.
To activate
remote
control:
1
M
u
Press the MENU/OK button ONCE then U
ONCE
! Display shows Main Menu > Answ. Machine
2
M
u
Press the MENU/OK button then U ONCE
! Display shows Answ. Machine > Settings
3
M
d
Press the MENU/OK button ONCE then D
ONCE
! Display shows Settings > Remote Access
4
M
Press the MENU/OK button
! Display shows Remote access > Off
5
d Press the U or D button to select between On
and Off
Display shows Remote access > On
6
M
Press the MENU/OK button to confirm the
selection
! You will hear a confirmation beep
7
B
f
Use the BACK button to exit the menu or press
HANG UP to go to standby mode
iDect_V2i_IFU_master.book Page 36 Thursday, March 27, 2008 2:54 PM