Binatone iDECT V2i System - Recall Time

44
Custom settings
Recall time The default value of the recall (also called Flash) time
that is preset in your handset is correct for most UK
lines, but you may need to change it if you are connected
to a PBX. There are three options available: Short
(85ms),
Medium (default, 100ms) and Long (250ms).
To set the
recall time:
1
M
Press the MENU/OK button
! The display shows Main Menu > Phonebook
2
d Press the D button THREE times
! The display shows Main Menu > Advanced Set
3
M
Press the MENU/OK button
! Display shows Advanced Set > Recall Time
4
M
Press the MENU/OK button
! Display shows Recall Time > Medium
5
:
Use the U or D button to select Short , Medium or
Long .
6
M
Press the MENU/OK button
! You will hear a confirmation beep.
7
B
f
Use the BACK button to exit the menu or press
HANG UP to go to standby mode
iDect_V2i_IFU_master.book Page 44 Thursday, March 27, 2008 2:54 PM