Binder FP 53 - Page 39

FP (E1.1) 07/2017 page 39/90
Normal Display
Display 1 shows
e.g. 19.8
(actual temperature value)
Display 2 shows e.g. 15.05.06 13:52 - -
(actual date and time, actual switching state of week
program timer channel 1: Off, channel 2: Off)
Press down key for 5 sec
Display 1 shows
e.g. 0000
Display 2 shows
PROGRAM EDITOR
(you are in the program editor)
Press down key for 5 sec
Display 1 shows
0000
Menu visible only if week program timer is activated.
Display 2 shows
WEEK PROG. EDITOR
(you are in the week program editor)
Press down key for 5 sec
Display 1 shows
0000
Display 2 shows
USER – LEVEL
(you are in the user level)
Hit program key
Display 1 shows
0000
Display 2 shows
UserCod?
0000
(enter user code, display flashes)
Enter the user code with arrow keys
e.g. 0001 (basic setting,
or the valid code in case it has been previously
changed in this menu).
Value is displayed in both displays.
Automatically forward after 2 sec
Display 1 shows
1
(actual address: 1)
Display 2 shows Adress 1
(entry of chamber address)
(actual address: 1)
Enter the chamber
address (1 up to 254)
with arrow keys
Address is displayed in both displays.
Hit key
Display 1 shows
1
(actually valid user code: 1)
Display 2 shows User-cod 1
(change user code)
(actually set: 1)
Enter a new value with arrow keys Value is displayed in both displays.
Hit key
Display 1 shows
0000
(no function)
Display 2 shows
Saf.mode: Limit
(no function)
Hit key
Display 1 shows
0
(no function)
Display 2 shows
Saf.setp
0
(no function)
Hit key
Display 1 shows
0000
(no function)
Display 2 shows Decimal: XXX.X
(setting of decimal point position)
(actual setting: XXX.X)
Select decimal point
position with arrow
keys
Decimal point position XXX.X or XXXX. is
displayed in display 2.