Binder FP 53 - Page 40

FP (E1.1) 07/2017 page 40/90
Hit key
Display 1 shows
0000
(no function)
Display 2 shows Buzzer : Active
(setting of the alarm buzzer)
(actual setting: „Active“)
Select between “Active” and “Inactiv” with
arrow keys
Setting is displayed in display 2.
Hit key
Display 1 shows
0000
(no function)
Display 2 shows Language : English
(selection of controller language)
(actual setting: English)
Select between languages German, English,
and French with arrow keys
Setting is displayed in display 2.
Hit key
Display 1 shows
e.g. 0004
(chamber operating hours)
Display 2 shows Oper.hs 0004:28
(operating hours up to now hhhh:mm)
(actually displayed: 4 hs 28 min)
Hit key
Display 1 shows
1000
(actual setting: 1000 hs)
Display 2 shows Op.limit
1000:00
(maximum number of operating hours
hhhh:mm (actual setting: 1000 hs)
Set value with arrow keys Setting is displayed in both displays.
Hit key
Display 1 shows
0000
(no function)
Display 2 shows Op.back : No
(reset counter of operating hours ?)
(actual setting: No)
Select between “Yes” and “No” with arrow
keys
Setting is displayed in display 2.
Hit key
Display 1 shows
0000
(no function)
Display 2 shows Protocol: MODBUS
(Selection of interface mode)
(actual setting: Modbus)
Select between protocols “MODBUS” and
“Printer” with arrow keys
Setting is displayed in display 2.
Hit key
Display 1 shows
e.g. 3
(actual setting: 3 min)
Display 2 shows Prt-Inv. 3
(print interval)
(actual setting: 3 min)
Select value between 0 and 255 minutes
with arrow keys
Setting is displayed in displays 1 and 2.