October152009–InstallationGuideDraft–EditPurposesOnly Page15
Installation Guide – October 2009 – Edit Purposes Only
2009
1.2.8.1 ELECTRO-STATIC DISCHARGE
L-1 Identity Solutions recommends that Administrators inform Users of these points
during the enrollment process:
9 Always use the Ridge-Lock to position a finger *before* touching the
sensor.
9 Always stand on the ESD-dissipative floor covering (if installed).
9 Do not touch other people or objects when touching the sensor.
9 Always maintain at least 12 inches of space around yourself when
touching the sensor.
9 Do not allow articles of clothing to touch the sensor.
L-1 Identity Solutions recommends that Installers always follow these points (in addition
to the points listed above):
9 When installing or working on a unit, always use a grounding wrist-
strap that is connected to a quality Earth ground.
9 Check the device's cabling for ground faults.
9 Ensure that the device's ground connection (located on the rear of the
device) is connected to a quality Earth Ground.
1.2.8.2 DEVICE HANDLING GUIDELINES
9 Do not install the device in locations where the device would be
exposed to direct sunlight, high levels of relative humidity, particulate
matter, or flammable vapors.
9 Do not install the device near radiators or other heat sources.
9 Do not allow magnetic objects to come within close proximity to the
device.
9 Strong magnetic fields might damage the device.
9 Do not let liquids Card the device.
9 Do not attempt to alter the device for any reason.Modifications will
void the product guarantee.
9 Do not attempt to disassemble the device in any way beyond what is
necessary for sensor field replacement.
9 Do not use the device for any purpose other than for what it was
designed.
To Next Page
Loading...