October152009–InstallationGuideDraft–EditPurposesOnly Page39
Installation Guide – October 2009 – Edit Purposes Only
2009
3.1.2 SECUREADMIN CLIENT
To install the SecureAdmin client software, follow these steps:
1. Insert the CD into the optical drive. If Autoplay is enabled, the installation process
will start automatically. A menu is displayed. If Autoplay is not enabled, start the
installation process manually by doubleclicking the Setup.exe file located in the
SecureAdmin folder on the CD.
Figure 3-13 Menu
Click Client Installation. The InstallShield Wizard is started and the target system is
examined. The Welcome screen is displayed.
To Next Page
Loading...