October152009–InstallationGuideDraft–EditPurposesOnly Page18
Installation Guide – October 2009 – Edit Purposes Only
2009
9 V-Series 4G devices are intended for indoor use only.
If you have any unresolved issues with the items on this list, contact L-1 Identity
Solutions Technical Support for additional information before beginning any installation.
WARNING
V-Station 4G and V-Flex 4G devices should be installed
by only a qualified technician. If you are not qualified to
perform an installation task, call L-1 Identity Solutions
Technical Support or contact a qualified installer.
2.1.1 RECOMENDED STEPS FOR A SUCCESSFUL INSTALLATION
Every installation is unique. Sometimes the issues are well defined and can be handled
in a standard fashion; sometimes the issues are very specific and may not be
immediately recognizable.
L-1 Identity Solutions recommends following these steps for a successful installation:
9 Plan the installation Choose the type of hardware required, decide if a
network is required, and decide on the location and number of required
devices.
9 Unpack all items Unpack all items and check against the packing list.
9 Install network hardware components Install the cabling and
components needed to run the system.
9 Install software Install the software needed to set up the devices.
9 Preconfigure device Connect the device to the USB cable, supply
power to the device, and preconfigure the device.
9 Mount devices Mount the devices in their final locations
9 Power distribution and device hook up Connect the device wiring via
the back panel.
9 Power-up procedure Check the power connections and start the
system safely. Enroll users Enroll users into the system (for user
enrollment procedures).
Chapters 3 through 7 in this document present more information on these steps.
To Next Page
Loading...