36 | 405 TS Getting Started Guide
Important guidelines:
l Always put the plate on the carrier with well A1
in the back, left corner of the carrier.
l Clean the plate after each use if you are using
wash buffer to run the test.
l Fully dry the plate after each use and before
putting it back in its foam-lined box.
l Inspect the plate regularly for damage, e.g.
scratches, chips, warping.
l Replace the plate when it is damaged. See
Replacement Procedure for Verify Test Plate in
the operator's manual.
405™ TS Microplate Washer
To Next Page
Loading...
