Optimize Performance| 39
Running Predefined Protocols
BioTek provides numerous predefined protocols for maintaining the instrument in
top condition and for qualifying its performance. Review the Predefined
Protocols on page 41.
To run a defined protocol:
LHC Touch screen
1.
Select Open and locate the 405 TS
folder.
2. Open the 405 TS folder. Find the desired
protocol for your instrument model.
Important: Be sure to Customize the
Predefined Protocols below
1. Touch a protocol on the
Home screen to select it.
2. Press Start to run it.
Creating Protocols: Washing, Aspirating and Dispensing Fluid
In addition to the quick routines available from the touch screen's Home screen, you
can define and run protocols. Protocols offer more parameters, giving you the ability
to fine-tune instrument performance, and perform more complex processing.
Touch Screen Control
See Create or Modify a Protocol on page 32
Liquid Handling Control™ (LHC) Software
Launch the LHC software to create or modify protocols, see on page 1on page 1.
LHC Users Only: Customize the Predefined Protocols
BioTek provides predefined protocols for maintenance routines and instrument
qualification tests. You can quickly customize the protocols for regular use.
The LHC keeps track of the last-used COM port for an instrument type. For example, when
an EL406 runs a protocol, the LHC logs the COM port used and the next time an EL406 is used,
the LHC applies the same COM port setting. You can disable this feature by defining your
Ports preference: select Tools>Preferences>Ports.
BioTek Instruments, Inc.
To Next Page
Loading...
