Operating instructions iS10 / iS20 About the device
38019417000 en 13
2
supply voltage
The permitted values can be found on the device identification plate and in the Technical
data.
Written permission for changes
Modifications to the devices require our prior written consent.
Repairs on the device may only be performed by the manufacturer or
authorized specialist workshops.
2.12 Software
The device has a software download.
A software must only be loaded if approved by the owner of the meas-
uring device.
2.13 Load receptor (optional)
Free-standing, unfixed and mobile scales are equipped with a level. After each change of
location check if the load receptor is horizontally aligned.
Load receptors may only be loaded up to the maximum approved load. The maximum load
can be found on the type plate of the load receptor.
2.14 Warranty
Installation, putting into operation as well as initial instruction regarding operation is carried
out by Bizerba Customer Service, Bizerba specialists or companies commissioned by Bi-
zerba.
Warranty for defects shall not exist in particular if and insofar as the defects occurred to
the delivered goods or to assets of the ordering party are attributable to the following rea-
sons:
– Non-observance of operating conditions
– Non-adherence to the technical documentation
– Defective electrical installation by the customer
– Structural modifications to the equipment
– Incorrect programming and operation
– Missing backup
– Natural wear and tear
– Wrong cleaning agent
To Next Page
Loading...
Need help?
General
