Operating instructions VS12 /C /F /F-P /W Installation
6.080.98.5.10.13 en 4 - 1
4
4 Installation
4.1 Transport and storage
When transporting the machine, shoes with toe caps must be worn and
suitable lifting devices must be used.
At least two persons are necessary to move the machine. Weight of
machine is higher than 25 kg.
Before installation, store and transport the machine in the original packaging.
The machine has to be transported and stored in accordance with the symbols on the
packaging.
4.2 Installation and assembly
Installation, start-up, as well as instructions on how to operate, clean, maintain and service
the device are provided for the first time by the relevant Bizerba customer services or the
Bizerba trade consultant.
Only lift the machine at the lifting straps. The drawing "Packing/unpacking the machine" is
included.
The lifting straps must only be used for machine handling before un-
packing. They must not be used as load-carrying equipment.
CAUTION Risk of crushing!
Carriage might move due to its unladen weight.
–
Be careful when unpacking.
4.2.1 Installation requirements
The installation surface needs to:
–
provide sufficient space, Dimensions, see chapter 9.1 until 9.6
– be horizontal and flat
– be slip-proof and tilt-proof
– be stable and rigid, Machine weight, see chapter 9.1 until 9.6
The recommended table height is approx. 800 mm.
To Next Page
Loading...
