Operating instructions VS12 /C /F /F-P /W Installation
6.080.98.5.10.13 en 4 - 3
4
Measures for suppressing interference:
With severely contaminated mains supplies (e.g. when "thyristor-controlled systems" are
used) measures must be taken on-site to suppress interferences, e.g.:
–
A separate supply line must be planned for Bizerba machines
– In problem cases, install capacitive decoupled isolating transformers or other sup-
pressors into the supply mains prior to Bizerba machines
4.3 Start-up
Initial start-up as well as instructions on how to operate, clean, maintain and service the
machine are initially provided by the responsible Bizerba service department or by a Bizer-
ba specialist.
4.3.1 Switching the slicer on
Press the green key <I>.
White lamp goes on.
The blade motor is turning.
4.3.2 Switching the machine off
Press <O> (red). (reduced operating force)
The machine is switched off.
4.4 Placing out of operation
If the machine is not going to be used for a longer period of time:
Switch off machine.
Pull out power plug.
Clean machine as per cleaning instructions.
To Next Page
Loading...
Need help?
General
