Operating instructions VS12 /C /F /F-P /W Maintenance
6.080.98.5.10.13 en 8 - 17
8
8.6.7 Removing sharpening dust
– Slice thickness to "0"
– Power plug is pulled
– Wear cut-resistant gloves
– Blade cover removed
Fig. 60: Blade cleaning
Press dry disposable cleaning towel to
blade surface and slowly clean from
center to outside.
Clean the back of the blade in the same
manner.
Fig. 61: Blade guard ring
From the front, insert a dry disposable
cleaning cloth between the blade and
the guard ring.
Use your hands to turn the blade and
the disposable cleaning cloth; while you
are doing so, press the cloth lightly
against the inside of the guard ring.
Machine housing:
Remove sharpening dust from the surfaces with either a dry disposable cleaning cloth
or brush.
If necessary, carry out a complete cleaning cycle.
To Next Page
Loading...
Need help?
General
