Blastrac 500 E Global - 6.5 What to do if a fault occurs; 6.6 Safety shutdown; 6.7 Restarting after a fault

Operating Instructions 500 E Global
Operation
6
6.5 What to do if a fault occurs
Irrespective of the following information, the local safety regulations
are valid in any case for the operation of the machine.
First put the machine to its Safety off position. After that start
looking for the defect.
6.6 Safety shutdown
The machine must be put to its safety off position before starting
repair works. See Chapter 2 “Safety instructions”.
6.7 Restarting after a fault
See Chapter 5 “Initial operation“.
All persons in the proximity of the machine must wear safety glasses
with lateral protection as well as safety shoes. The operator is
obliged to wear close-fitting protective clothing.