6 Calls
51
• Voicemail : Configure voicemail settings.
–
Notifications
–
Importance : Set the notification importance to Urgent, High (default), Medium, or Low.
–
Sound : Select a sound to play when a voicemail is received.
–
Vibrate : Set vibrate to On (default) or Off.
–
Advanced : Use toggle switches to enable or disable Blink link, Show notification, or Override Do
Not Disturb. Available options vary depending on the Importance setting.
–
Advanced Settings
–
Service : Set the service provider or other provider for voicemail service.
–
Setup : Select to update the phone number used to access voicemail.
–
Accessibility
–
TTY mode : Touch to set the TTY setting. Use an optional teletypewriter (TTY) with the device to send
and receive calls. Plug the TTY into the device headset jack and set the device to operate in one of
theTTY modes.
Use a TSB-121 compliant cable (provided by the TTY manufacturer) to connect the TTY to the device.
Set the device volume to a middle level setting for proper operation. If you experience a high number of
incorrect characters, adjust the volume as needed to minimize the error rate.
For optimal performance, the device should be at least 30 cm (12 inches) from the TTY. Placing the
device too close to the TTY may cause high error rates.
–
TTY off : TTY is off (default)
–
TTY Full : Transmit and receive TTY characters
–
TTY HCO : Transmit TTY characters, but receive by listening to earpiece
–
TTY VCO : Receive TTY characters, but transmit by speaking into microphone.
–
Hearing aids : Select to enable hearing air compatibility.
–
RTT settings : Configure Real-time text (RTT) settings.
–
Real-time text (RTT) call : Select to allow messaging during a call.
–
Set RTT visibility : Set to Visible during calls (default) or Always visible.
To Next Page
Loading...
