What to do if my Bluetti Audio & Video Accessories display 'PV1 ISO Failure'?
If your Bluetti Audio & Video Accessories display 'PV1 ISO Failure', check the insulation resistor between the solar array and grounding for a short circuit.
What to do if my Bluetti Audio & Video Accessories display 'Phase Sequence Error'?
If your Bluetti Audio & Video Accessories display 'Phase Sequence Error', check if the grid connection meets installation requirements.
What to do if my Bluetti Audio & Video Accessories display 'GFCI Failure'?
If your Bluetti Audio & Video Accessories display 'GFCI Failure', check if the AC output PE wire is grounded.
What to do if Bluetti EP600 Storage shows PV1 Overcurrent?
To address the 'PV1 Overcurrent' error on your Bluetti storage, turn off the inverter, wait for 30 minutes, and then restart it. If the problem remains, please contact the BLUETTI support team.
What to do if Bluetti Storage shows BMS Communication Interrupted?
To address the 'BMS Communication Interrupted' error on your Bluetti storage, turn off the inverter, wait for 30 minutes, and then restart it. If the problem remains, please contact the BLUETTI support team.
What causes PV1 Voltage Low on Bluetti EP600?
Check the PV setup. Solar panels may get a low voltage without proper working conditions.
What to do if I see 'Grid Voltage High-ARM' on my Bluetti Audio & Video Accessories?
If the 'Grid Voltage High-ARM' error occurs frequently on your Bluetti Audio & Video Accessories, verify that the grid voltage and frequency meet the inverter's input specifications. Also, check the inverter's AC circuit breaker and connections. If the voltage and frequency are beyond the specified range, contact the BLUETTI support team.
What to do if I see 'Grid Voltage High' on my Bluetti Audio & Video Accessories?
If the 'Grid Voltage High' error occurs occasionally on your Bluetti Audio & Video Accessories, it may indicate abnormal grid conditions, and the inverter should recover once the grid stabilizes. However, if it happens frequently, verify that the grid voltage and frequency meet the inverter's input specifications. Also, check the inverter's AC circuit breaker and connections. If the voltage and frequency are out of range, contact the BLUETTI support team.
What to do if my Bluetti Portable Generator displays USB Upgrade Failure?
If your Bluetti Portable Generator displays a USB Upgrade Failure, turn the inverter on again. If the symptom persists, please contact the BLUETTI support team.
What to do if my Bluetti Portable Generator displays BMS Charge Protection?
If your Bluetti Portable Generator displays a BMS Charge Protection error, check the details on the BLUETTI app.
General| Shape | Rectangle |
|---|---|
| Certification | UL9540A, UL1973, UKCA, RCM, PSE, ICES, FCC, CE, CB |
| Built-in display | - |
| Suitable for outdoor use | Yes |
| Power protection features | Overheating, Reverse polarity, Under voltage |
| International Protection (IP) code | IP65 |
| Waveform | Pure sine |
| Input voltage | 150 - 500 V |
| Output voltage | 230/400 V |
| Charging source | AC, Solar |
| Battery capacity | - mAh |
| Battery technology | Lithium Iron Phosphate (LiFePO4) |
| Total output power | 6000 W |
| Output current (max) | 8.7 A |
| Operating temperature (T-T) | -20 - 50 °C |
| Operating relative humidity (H-H) | 5 - 95 % |
Weight and Dimensions| Depth | 325 mm |
|---|---|
| Width | 636 mm |
| Height | 370 mm |
| Weight | 40000 g |
To Next Page
