ACM200 USER MANUAL
22 www.blustream.co.uk / www.blustream.com.au
Web-GUI - Receivers
The Receiver summary window gives an overview of all the Receiver devices that have been configured within the
system, with the ability to update the system as required.
Features of the Receiver summary page include:
1. ID / Output - the ID / output number is used for control of the Multicast system when using third party drivers.
2. Name - the name of the Receivers (typically the device attached to the Receiver) are automatically assigned
default names i.e. Receiver 001 etc. Receiver names can be amended within the Device Setup page (within the
Wizard), or by clicking on the 'Actions' button for an individual unit - see page 23.
3. IP Address - the IP address assigned to the Receiver during configuration.
4. MAC Address - shows the unique MAC address of the Receiver.
5. Firmware - displays the firmware version currently loaded onto the Receiver. For more information on updating
firmware, please see 'Update Devices
6. Status - shows the online / oline status of each Receiver. Should a device show as being 'Oline', check the
units connectivity to the network switch.
7. Source - shows the current source selected at each Receiver. To switch source selection, choose a new
Transmitter from the drop-down selection.
8. Resolution - adjust the output resolution using the built-in video scaler inside the Multicast Receiver. The scaler
is capable of both upscaling and downscaling the incoming video signal. Output resolutions include:
- Pass Through - the Receiver will output the same resolution that the source is outputting up to 4K 30Hz output
- 2160p @ 30Hz
- 2160p @ 24Hz - 1280x1024 @ 60Hz
- 1080p @ 60Hz - 1024x768 @ 60Hz
- 1080p @ 50Hz - 1360x768 @ 60Hz
- 720p @ 60Hz - 1440x900 @ 60Hz
- 720p @ 50Hz - 1680x1050 @ 60Hz
9. HDR On/O - turns on HDR (High Dynamic Range) compatibillity - only use with screens that support HDR.
10. Function - identifies the Receiver as a standalone device (Matrix) or as part of a Video Wall.
11. Actions - see next for breakdown of additional actions options
12. Scaling Help - you can obtain some basic help with scaling selection by clicking the button at the top of the
page marked 'Scaling Help'. See page 24 for more information.
13. Refresh - click here to refresh all current information on the devices within the system.
To Next Page
Loading...
Need help?
General