Need help?Do you have a question about the BMPRO BatteryPlus35SR and is the answer not in the manual?
General| Input Frequency | 50Hz |
|---|---|
| Output Current | 35A |
| Operating Temperature | 0°C to 50°C |
| Battery Type | AGM, Gel, Lithium |
| Protection Features | Over Current, Short Circuit, Reverse Polarity, Over Temperature |
Lists accessories provided with the product.
Describes the Trek display and its features.
Describes the RVView display and its features.
Explains the power supply's AC/DC operation and output.
Details how multiple power sources are managed.
Discusses installation environment and heat management.
Recommendations for DC cable sizing.
How to connect 12V loads to the unit.
Details on using an external DC source.
How to connect solar panels or controllers.
Connecting other BMPRO accessories.
Steps to safely disconnect the battery.
Steps to safely connect the battery.
Guidelines for connecting multiple batteries.
Information about servicing and internal parts.
Schematic overview of the system's components.
How different inputs are prioritized and combined.
Description of internal electronic fuses for loads.
Requirements for external battery fuse.
Fuse requirements for the AX input.
Details on the ECO low voltage disconnect mode.
Details on the Storage low voltage disconnect mode.
How AC mains charges the battery.
How solar power charges the battery.
Voltage and current settings for charging.
Initial charging phase details.
Main charging phase details.
Maintaining charge level.
LED indicators for individual load outputs.
Critical safety warnings before installation.
List of accessories provided with the Trek unit.
Definitions of key terms used in the manual.
What happens when the Trek unit is first powered on.
Steps to enter the setup mode.
Navigation and options within the setup menu.
How to configure the 12-hour clock format.
How to configure the 24-hour clock format.
How to enable or disable water tanks.
Changing tank type from fresh to waste.
Configuring the low battery warning threshold.
Adjusting the display's backlight brightness.
Description of the unit's connectors.
Recommends an indoor, dry installation area.
Instructions on how to mount the Trek unit.
Steps for installing a digital water level sensor.
Technical specifications for the Trek unit.
Information on repairs and support for Trek.
How to access the advanced configuration menu.
Adjusting the bulk charging voltage setting.
Managing external shunt status.
Critical safety warnings for RVView installation.
Overview of the RVView display unit.
Explains the information shown on the RVView display.
Information on repairs and support for RVView.
Instructions for installing the RVView unit.
Recommends an indoor, dry installation area for RVView.
Instructions for mounting the RVView display.
To Next Page
